Do tej pory zawsze wykonywałem czynności w następującej kolejności:
1. Włączałem wzmacniacz/energizer.
2. Podłączałem słuchawki.
Dokładnie jak w manualu tranzytorowego
Stax SRM-727 II● Insert the attached power cord into the AC inlet ⑩ on the rear panel and insert the plug into the power socket.
● Connect the device you wish to use for listening purposes into the input terminal ⑤ ⑥ on the rear panel.
● The LED ① will come on if the power switch ② is pushed. Sound can be produced when you hear a clicking noise.
● Insert the earspeaker you intend to use into the earspeaker power socket ③ on the front panel and adjust to the optimum volume by turning the volume knob gradually to the right.
albo lampowego
Stax SRM-007t II● Insert the attached power cord into the AC Inlet (12) on the rear panel, insert the AC plug into a wall socket, and press the power switch (1) to turn the power on.
● The Pilot Lamp (2) will flash for about 18 seconds while the heater of the vacuum tube is warming up. It will enter the operating state when the light comes on steadily.
● Insert the earspeaker you are going to use into the Earspeaker Power Socket (4) on the front panel, and gradually turn the Volume Knob (5) to the right until you achieve the desired volume.
Na dniach spodziewam się
Trilogy H1. Uderzył mnie następujący fragment w jego manualu:
WARNING! Plug the Earspeakers or electrostatic headphones into the H1 before switching on.
When using extension leads make sure these are plugged in before switching on.
Zacząłem sprawdzać inne wzmaki elektrostatyczne, nie zawsze procedura jest opisana, ale np.
Woo Audio 3ES Electrostatic Headphone Amplifier podaje nastepujący schemat podstępowania:
Turning the amplifier on:
1. Turn the volume knob to the lowest position.
2. Insert a headphone into headphone output
3. Turn the standard-by power switch knob from left to right until you hear a click sound. The LED will light.
4. Observe that all tubes light gradually.
5. Let the tubes warm up for at least 1 minute.
6. Turn the power switch knob from left to right until you hear a click sound.
7. The amplifier is now in operation.
...FAQ...
Q: Can I change headphone while the amplifier is on?
A: Yes, but you must first minimize the volume.
No więc mam zagwostkę. Jakoś dziwnie się czuję z tymi dwoma podejściami. Czy ktoś ma jakieś przemyślenia na ten temat?
